![]() ![]() The resin detached from the models hardens due to the natural UV light. You always have to clean the wash container of the Elegoo Mercury Plus. In particular, the noise when washing your models and the noise when pressing the buttons can be somewhat annoying and are described by some users as very loud and unpleasant. ![]() The Mercury Plus is unfortunately relatively loud in operation. According to the manufacturer, the yellow-transparent acrylic hood should block around 99.95% of the UV light from the LEDs. The hood must also always be put on so that you can switch on the device. This prevents you from looking unprotected into the glowing UV LEDs or being hit by splashes from a mixture of wash solution and resin. If you remove the hood during curing or washing, the device is automatically switched off. The device is equipped with a safety shutdown. A rotating platform for post-curing your models, tools, a power supply unit and an instruction manual are also included.Įlegoo has also thought about your safety when designing the Mercury Plus. The Elegoo Mercury Plus comes with a wash container with matching wash basket and a holder for different build platforms. Dimensions: 200 x 200 x 353 mm (L x W x H).The distance between the four buttons is large, so you can’t accidentally press two buttons at the same time. With the four buttons you select the operating mode, increase or decrease the timer and start the device. The display shows you the remaining time of the timer and the operating mode. The display and the buttons are located on the front of the device base. For operation, Elegoo has equipped the Mercury Plus – Wash & Cure with 4 touch keys and a small display. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |